解压后拖到klipper文件夹所在的用户目录
执行install.sh

[idm]
serial:/dev/serial/by-id/usb-IDM_614e_473431383817584A-if00

#/dev/serial/by-id/usb-1a86_USB2.0-Ser_-if00-port0
#   Path to the serial port for the idm device. Typically has the form
#   /dev/serial/by-id/usb-idm_idm_...
speed: 40.
#   Z probing dive speed.
lift_speed: 5.
#   Z probing lift speed.
backlash_comp: 0.5
#   Backlash compensation distance for removing Z backlash before measuring
#   the sensor response.
x_offset: 0.
#   X offset of idm from the nozzle.
y_offset: 21.1
#   Y offset of idm from the nozzle.
trigger_distance: 2.
#   idm trigger distance for homing.
trigger_dive_threshold: 1.5
#   Threshold for range vs dive mode probing. Beyond `trigger_distance +
#   trigger_dive_threshold` a dive will be used.
trigger_hysteresis: 0.006
#   Hysteresis on trigger threshold for untriggering, as a percentage of the
#   trigger threshold.
cal_nozzle_z: 0.1
#   Expected nozzle offset after completing manual Z offset calibration.
cal_floor: 0.1
#   Minimum z bound on sensor response measurement.
cal_ceil:5.
#   Maximum z bound on sensor response measurement.
cal_speed: 1.0
#   Speed while measuring response curve.
cal_move_speed: 10.
#   Speed while moving to position for response curve measurement.
default_model_name: default
#   Name of default idm model to load.
mesh_main_direction: y
#   Primary travel direction during mesh measurement.
#mesh_overscan: -1
#   Distance to use for direction changes at mesh line ends. Omit this setting
#   and a default will be calculated from line spacing and available travel.
mesh_cluster_size: 1
#   Radius of mesh grid point clusters.
mesh_runs: 2
#   Number of passes to make during mesh scan.
serial改成你自己的
probe项可以删了