diff --git a/中文教程/klipper官方涡流传感器相关配置.md b/中文教程/klipper官方涡流传感器相关配置.md
new file mode 100644
index 0000000..c823c36
--- /dev/null
+++ b/中文教程/klipper官方涡流传感器相关配置.md
@@ -0,0 +1,63 @@
+### 固件视频
+刷入[klipper_eddy_firmware](/klipper_eddy_firmware)下的固件(根据通讯方式选择)  
+### 配置
+```
+[mcu idm]
+serial:
+#canbus_uuid:
+
+[probe_eddy_current eddy]
+sensor_type: ldc1612
+i2c_mcu: idm
+i2c_bus: i2c1
+x_offset: 0
+y_offset: 21.1
+speed:40
+lift_speed: 15.
+
+[thermistor ntc47k]
+temperature1:25.
+resistance1:47000
+beta:4010
+
+[probe_drift_adjust]
+sensor_type:ntc47k
+sensor_pin:idm:PA4
+pullup_resistor:10000
+```
+###  操作说明
+首先`SET_KINEMATIC_POSITION z=80`  
+然后控制打印头到热床中央2cm高的位置,执行`LDC_CALIBRATE_DRIVE_CURRENT CHIP=eddy`和`PROBE_EDDY_CURRENT_CALIBRATE CHIP=eddy`  
+此时校准步骤完成。  
+整床扫描使用`BED_MESH_CALIBRATE METHOD=scan SCAN_MODE=rapid`  
+
+### QGL使用扫描模式
+```
+[gcode_macro QUAD_GANTRY_LEVEL]   #随着龙门高低差降低降低探测高度
+rename_existing: _QUAD_GANTRY_LEVEL
+gcode:
+    SAVE_GCODE_STATE NAME=STATE_QGL
+    BED_MESH_CLEAR
+    {% if not printer.quad_gantry_level.applied %}
+      _QUAD_GANTRY_LEVEL horizontal_move_z=10 retry_tolerance=1
+    {% endif %}
+    _QUAD_GANTRY_LEVEL horizontal_move_z=2 METHOD=scan
+    # G28 Z
+    RESTORE_GCODE_STATE NAME=STATE_QGL
+```
+### z_tilt使用扫描模式
+```
+[gcode_macro Z_TILT_ADJUST]
+rename_existing: _Z_TILT_ADJUST
+gcode:
+    SAVE_GCODE_STATE NAME=STATE_Z_TILT
+    BED_MESH_CLEAR
+    {% if not printer.z_tilt.applied %}
+      _Z_TILT_ADJUST horizontal_move_z=10 retry_tolerance=1
+    {% endif %}
+    _Z_TILT_ADJUST horizontal_move_z=2 METHOD=scan
+    # G28 Z
+    RESTORE_GCODE_STATE NAME=STATE_Z_TILT
+```
+### 温补校准
+PROBE_DRIFT_CALIBRATE COUNT=6 AUTOSTEP=7
\ No newline at end of file