51 lines
1.7 KiB
Plaintext
51 lines
1.7 KiB
Plaintext
解压后拖到klipper文件夹所在的用户目录
|
|
执行install.sh
|
|
|
|
[idm]
|
|
serial:/dev/serial/by-id/usb-IDM_614e_473431383817584A-if00
|
|
|
|
#/dev/serial/by-id/usb-1a86_USB2.0-Ser_-if00-port0
|
|
# Path to the serial port for the idm device. Typically has the form
|
|
# /dev/serial/by-id/usb-idm_idm_...
|
|
speed: 40.
|
|
# Z probing dive speed.
|
|
lift_speed: 5.
|
|
# Z probing lift speed.
|
|
backlash_comp: 0.5
|
|
# Backlash compensation distance for removing Z backlash before measuring
|
|
# the sensor response.
|
|
x_offset: 0.
|
|
# X offset of idm from the nozzle.
|
|
y_offset: 21.1
|
|
# Y offset of idm from the nozzle.
|
|
trigger_distance: 2.
|
|
# idm trigger distance for homing.
|
|
trigger_dive_threshold: 1.5
|
|
# Threshold for range vs dive mode probing. Beyond `trigger_distance +
|
|
# trigger_dive_threshold` a dive will be used.
|
|
trigger_hysteresis: 0.006
|
|
# Hysteresis on trigger threshold for untriggering, as a percentage of the
|
|
# trigger threshold.
|
|
cal_nozzle_z: 0.1
|
|
# Expected nozzle offset after completing manual Z offset calibration.
|
|
cal_floor: 0.1
|
|
# Minimum z bound on sensor response measurement.
|
|
cal_ceil:5.
|
|
# Maximum z bound on sensor response measurement.
|
|
cal_speed: 1.0
|
|
# Speed while measuring response curve.
|
|
cal_move_speed: 10.
|
|
# Speed while moving to position for response curve measurement.
|
|
default_model_name: default
|
|
# Name of default idm model to load.
|
|
mesh_main_direction: y
|
|
# Primary travel direction during mesh measurement.
|
|
#mesh_overscan: -1
|
|
# Distance to use for direction changes at mesh line ends. Omit this setting
|
|
# and a default will be calculated from line spacing and available travel.
|
|
mesh_cluster_size: 1
|
|
# Radius of mesh grid point clusters.
|
|
mesh_runs: 2
|
|
# Number of passes to make during mesh scan.
|
|
serial改成你自己的
|
|
probe项可以删了 |